Beghelli Salvalavista LED 3316 Leaflet
Product codes
3316
w w w . b e g h e l l i . c o m
BEGHELLI S.p.A. - Via Mozzeghine 13, 15
40050 MONTEVEGLIO (BO)
Tel. +39 051 9660411
Fax +39 051 9660444
334.900.968
INSTRUCTIONS FOR USE
GB
SalvalavistaLED Beghelli is a specifically calibrated LED electronic device that with his soft lighting emission, prevents visual fatigue and con-
siderably improves TV images.
siderably improves TV images.
Positioning:
- Remove the protective film from the rubber grip (1);
- place the device under or on the rear of the TV set (2);
- connect the device to the mains at 230V and the TV to the electrical outlet placed on the back of
- Remove the protective film from the rubber grip (1);
- place the device under or on the rear of the TV set (2);
- connect the device to the mains at 230V and the TV to the electrical outlet placed on the back of
SalvalavistaLED (3).
Switching on:
1) automatically:
SalvalavistaLED automatically switches on and off*** with TV set.
The device can be switched off by pressing button (4); it will switch automatically on with the TV set.
1) automatically:
SalvalavistaLED automatically switches on and off*** with TV set.
The device can be switched off by pressing button (4); it will switch automatically on with the TV set.
2) manually:
SalvalavistaLED manually switches on and off with an on/off button placed on the top (4) independently from the TV set.
SalvalavistaLED manually switches on and off with an on/off button placed on the top (4) independently from the TV set.
Setting of luminous intensity:
A sustained pressure of button (4) allows to increase or reduce the light intensity. To obtain the desired light intensity a constant pressure on
this button is needed.
this button is needed.
***
If the first time of use, the
If the first time of use, the
SalvalavistaLED does not switch on with TV, the following steps should be followed:
- remove TV plug from
SalvalavistaLED outlet;
- disconnect
SalvalavistaLED plug from mains ( 230V);
- connect
SalvalavistaLED to the mains (230V) by pressing button (4);
- release the button;
- connect the TV set by inserting its plug into
- connect the TV set by inserting its plug into
SalvalavistaLED outlet;
- press
SalvalavistaLED button for at least 5 seconds until the device switches on;
- press
SalvalavistaLED button until the device switches off.
TECHNICAL CHARACTERISTICS
Order Code
3316
Light source (LED)
1W
Electrical input
230V ÷ 0,2/2,5W
CAUTIONARY NOTES / WARRANTY
- This equipment must be used solely for the purpose for which it was built. Any other use is to be considered improper and dangerous.
- For every repairs, contact an authorised service centre and request that original spare parts be used. Failure to do so may compromise
- For every repairs, contact an authorised service centre and request that original spare parts be used. Failure to do so may compromise
the safety of the equipment.
- If the power cable is damaged, it must be replaced by the Manufacturer or authorised technical assistance supplier.
- The device may not be disposed of as ordinary municipal solid waste. It must be separately collected to avoid damage to the
- The device may not be disposed of as ordinary municipal solid waste. It must be separately collected to avoid damage to the
environment. Under EC Directive 2002/96 and relevant national laws on the disposal of products at the end of their useful life, failure
to comply with the above restriction is punishable by law.
to comply with the above restriction is punishable by law.
- For information on the terms of the warranty service contact an authorised dealer.