Hitachi 100GB 7200 RPM HTE721010G9SA00 User Manual
Product codes
HTE721010G9SA00
Travelstar E7K100 (Serial ATA) Hard Disk Drive Specification
39
8.0 General
8.1 Introduction
This specification describes the host interface of the Travelstar E7K100 hard disk drive.
The interface conforms to the Working Document of Information technology with certain limitations described in
8.0, "Deviations From Standard."
8.0, "Deviations From Standard."
- Serial ATA: High Speed Serialized AT Attachement Revision 1.0a dated on 7 January 2003
- Serial ATA II: Extensions to Serial ATA 1.0a Revision 1.2 dated on 27 August 2004
- AT Attachment with Packet Interface Extension (ATA/ATAPI-7) Revision 4b dated on 21 April 2004
HTE7210XXG9SA00 support the following functions as Vendor Specific Function:
• Format Unit Function
• Sense Condition Command
• Sense Condition Command
8.3 Deviations from standard
The device conforms to the referenced specifications with the following deviations described below.
The interface conforms to the Working Document of Information Technology, AT Attachment with Packet Interface
Extension (ATA/ATAPI-7) Revision 4b dated 21 April 2004, with deviation as follows.
Extension (ATA/ATAPI-7) Revision 4b dated 21 April 2004, with deviation as follows.
Write Verify WRITE VERIFY command does not include read verification after write operation. The
function is exactly same as WRITE SECTORS command.
function is exactly same as WRITE SECTORS command.
S.M.A.R.T. Return StatusS.M.A.R.T. RETURN STATUS subcommand does not check advisory
attributes. That is, the device will not report threshold exceeded condition unless prefailure attributes exceed
their corresponding thresholds. For example, Power-On Hours Attribute never results in negative reliability
status.
attributes. That is, the device will not report threshold exceeded condition unless prefailure attributes exceed
their corresponding thresholds. For example, Power-On Hours Attribute never results in negative reliability
status.
Check Power Mode Check Power Mode command returns FFh to Sector Count Register when the device
is in Idle mode. This command does not support 80h as the return value.
is in Idle mode. This command does not support 80h as the return value.
8.2 Terminology
Device
Device indicates HTE7210XXG9SA00
Host
Host indicates the system that the device is attached to.
INTRQ
Interrupt request (Device or Host)