Hitachi 100GB 7200 RPM HTE721010G9SA00 User Manual
Product codes
HTE721010G9SA00
Travelstar E7K100 (Serial ATA) Hard Disk Drive Specification
47
10.0 General operation descriptions
10.1 Reset response
ATA has the following three types of resets:
The actions of each reset are shown in the table below.
O – execute
X – does not execute
Notes:
Power On Reset (POR)
The device executes a series of electrical circuitry diagnostics, spins up the
head disk assembly, tests speed and other mechanical parametric, and sets
default values.
head disk assembly, tests speed and other mechanical parametric, and sets
default values.
COMRESET
COMRESET- is issued thought Out of Band (OOB) signal in Serial ATA bus.
Soft Reset (Software Reset)
The SRST bit in the Device Control Register is set and then is reset. The device
resets the interface circuitry according to the Set Features requirement.
resets the interface circuitry according to the Set Features requirement.
Table 28: Reset response table
POR
Comreset
soft reset
Aborting Host interface
-
O
O
Aborting Device operation
-
(*1)
(*1)
Initialization of hardware
O
X
X
Internal diagnostic
O
X
X
Spinning spindle
(*5)
X
X
Initialization of registers (*2)
0
O
O
Reverting programmed parameters to default
Number of CHS (set by Initialize
Device Parameters)
Multiple mode
Write Cache
Read look-ahead
ECC bytes
O
(*6)
(*3)
Disable Standby timer
0
(*6)
x
Power mode
(*5)
(*4)
(*4)
(*1)
Execute after the data in write cache has been written.
(*2)
The default value on POR is shown in Table 29: “Default Register Values” on page 48.
(*3)
The Set Features command with Feature register = CCh enables the device to revert these parameters to the
power on defaults.
power on defaults.
(*4)
In the case of Sleep mode, the device goes to Standby mode. In other cases, the device does not change current
mode.
mode.
(*5)
Idle when Power-Up in Standby feature set is disabled. Standby when Power-Up in Standby feature set is
enabled.
enabled.
(*6)
See section Software Setting Preservation feature.