Wilson Electronics Three way Splitter 859980 User Manual
Product codes
859980
1
2
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Mon.- Fri. Hours: 7 am to 6 pm MST.
1 . Install In-Building Signal Booster (such as the AG Pro 75
™ sold separately) . Use the
installation guide for the model you purchased to install .
2 . Select a location to install the In-Line that is away from excessive heat, direct
sunlight, moisture and has proper ventilation . Do not place the In-Line in an air-tight
enclosure .
3 . The In-Line should be placed where it can make up for installation gain loss due
to cable, taps or splitters . Optimal location is near or directly connected to the Inside
Antenna .
4 . a) Connect a cable to the In-Building Signal Booster at the connector labeled
“Inside Antenna .”
b) Run the cable to the In-Line, attach to the connector labeled “Outside Antenna .”
c) From the In-Line connector marked “Inside Antenna” run a cable to the Inside
c) From the In-Line connector marked “Inside Antenna” run a cable to the Inside
Antenna . For more information on running cable (refer to diagrams on pages
3 & 4) .
5 . Before powering up the In-Line, verify that all cables are connected and check
that all connections are tight .
Note: Be careful when plugging the connectors in so as not to bend the center
pins on the connectors .
6 . The In-Line has been packaged with the gain control knobs adjusted to the highest
gain position . If one or both of the lights are not green (refer to pages 9 & 10) .
Quick Install Overview
Refer to Installation Diagrams on page 3 & 4 . Contact Wilson Electronics Technical
Support Team with any questions at 866-294-1660 .
Warning:
Connecting the Signal Booster directly to a cell phone with use of
an adapter may damage the cell phone and/or the Signal Booster .