Philips Pocket projector PPX3610 PPX3610/EU User Manual

You can position the device so that it lies flat on a table 
in front of the projection surface; it is not necessary to 
tilt it towards the projection surface. The device com-
pensates for the distortion from the slanted projection 
(pincushion distortion).

Check whether the mains voltage of the 
power supply matches the mains voltage avail-
able at the setup location.

1 Insert the small plug of the power supply into the 

socket on the rear side of your device. 

2 Plug the power supply into the mains.

3 During the charging process, the indicator light on 

the side of the device will be red. When the battery 
is fully charged, it will turn green.

4 Charge the built-in battery completely before using 

for the first time. This will prolong the life of the bat-
tery.

VGA

Y-Pb-Pr

HDMI

The battery of the Pico Station will not be 
charged while the projector is in use.

The battery of the projector will not be 
charged while the projector is in use.

Only use the CR 2025 type battery.

1 To access the battery, disengage the locking mecha-

nism (

1) and slide out the battery compartment 

(

2).

2 Insert the new batteries into the battery compart-

ment with the positive and negative poles as shown 
on the back of the remote control. Make sure the 
polarities(+ and -) are aligned correctly.