Wilson Electronics 859994 User Manual

1 . Install In-Building Signal Booster (such as the AG Pro 75

™ sold separately) . Use the  

  installation guide for the model you purchased to install .

2 . Select a location to install the In-Line that is away from excessive heat, direct  

  sunlight, moisture and has proper ventilation . Do not place the In-Line in an air-tight  

 enclosure .

3 . The In-Line should be placed where it can make up for installation gain loss due  

  to cable, taps or splitters . Optimal location is near or directly connected to the Inside  

 Antenna . 

4 . a) Connect a cable to the In-Building Signal Booster at the connector labeled  

 

“Inside Antenna .”

b) Run the cable to the In-Line, attach to the connector labeled “Outside Antenna .”
c) From the In-Line connector marked “Inside Antenna” run a cable to the Inside  

  Antenna . For more information on running cable (refer to diagrams on pages  

  3 & 4) .

5 . Before powering up the In-Line, verify that all cables are connected and check  

  that all connections are tight .

 pins on the connectors .

6 . The In-Line has been packaged with the gain control knobs adjusted to the highest  

  gain position . If one or both of the lights are not green (refer to pages 9 & 10) .

Refer to Installation Diagrams on page 3 & 4 . Contact Wilson Electronics Technical 

Support Team with any questions at 866-294-1660 .

Connecting the Signal Booster directly to a cell phone with use of    

 

an adapter may damage the cell phone and/or the Signal Booster .