Philips PPX3610 PPX3610/F7 User Manual

Do not make any changes or settings that are not 
described in this user manual. Physical injury or damage 
to the device or loss of data can result from improper 
handling. Take note of all warning and safety notes indi-
cated.

The product is for indoor use only. The device should 
be placed securely on a stable, flat surface. Position all 
cables in such a way that no one will trip on them, thus 
avoiding possible injuries to persons or damage to the 
device itself.

Do not plug in the device in humid rooms. Never touch 
the electrical cable or the electrical connection with 
wet hands.

The device must have sufficient ventilation and may not 
be covered. Do not put your device in closed cabinets 
or boxes.

Do not place the device on soft surfaces such as table-
cloths or carpets and do not cover the ventilation slits. 
Otherwise the device could overheat or catch fire.

Protect the device against direct sunlight, heat, large 
temperature fluctuations and moisture. Do not place 
the device in the vicinity of heaters or air conditioners. 
Observe the information on temperature and humidity 
in the technical data.

When the device is running for a long period of time in 
fault condition (like ambient temperature over 35 °C or 
ventilation openings blocked), the surface becomes hot 
and a warning symbol appears on the projection (see 
also Symbols in the Statusbar, page 11). The device 
behaves as follows:

1 The fan turns to maximum level.

2 At maximum level of brightness the overheat symbol 

appears in the status bar and the device turns auto-
matically to minimum level of brightness.

3 At minimal level of brightness the overheat symbol 

shows for three seconds in the middle of the screen. 
Then the device turns off automatically.

After the device has cooled down, you can continue 
playback.

Do not allow liquids to enter into the device. Switch off 
the device and disconnect it from the power supply if 
liquids or foreign substances end up inside the device. 

Have the product inspected by a technical service 
department.

Always handle the product with care. Avoid touching 
the lens. Never place heavy or sharp objects on the pro-
jector or the power cable.

If the projector gets too hot or emits smoke, shut it 
down immediately and unplug the power cable. Arrange 
for your device to be investigated by a technical service 
centre. To prevent the spread of fire, open flames 
should be kept away from the device.

Under the following conditions, a layer of moisture can 
appear inside the device which can lead to malfunctions:

• if the device is moved from a cold to a warm 

area;

• after a cold room is heated;
• when this device is placed in a damp room.

Proceed as follows to avoid any moisture build-up:

1 Seal this device in a plastic bag before moving it to 

another room, in order for it to adapt to room con-
ditions.

2 Wait one to two hours before you take the device 

out of the plastic bag.

The device should not be used in a very dusty environ-
ment. Dust particles and other foreign objects may 
damage the product.

Do not expose the device to extreme vibrations. It may 
damage the internal components.

Do not allow children to handle the device without 
supervision. The packing materials should be kept out of 
the hands of children.

Do not repair the device yourself. Improper mainte-
nance can result in injuries or damage to the device. 
Your device must be repaired by an authorised service 
centre.

Find details of authorised service centres on the war-
ranty card.

Do not remove the type label from your device; this 
would void the warranty.