D-Link Bridge ENet Wless 11Mbps Remote station DWL-1800R User Manual

Product codes
DWL-1800R
Page of 4
IEEE 802.11b DSSS 2.4GHz standard
Up to 11Mbps data transfer rate
Indoor-outdoor architecture for maximum range and 
reliability
Optimized for outdoor building-to-building point-to-point, 
point-to-multipoint applications
Up to 25 km (15 miles) in FCC, 10 km in ETSI building-
to-building transmission range
DWL-1800
2.4GHz Wireless LAN
Features
The Outdoor Bridge consists of an Outdoor Unit 
and an Indoor Unit connected together by a 
water-proof interface cable. 
11Mbps 2.4GHz Wireless LAN Outdoor Bridge
The DWL-1800 series of 802.11b Wireless Outdoor Bridges connect LANs located in distant buildings at 11Mbps speed. These 
bridges operate without any network wires and have unique features designed specially for outdoor applications, making 
them an ideal solution for wireless building-to-building connection.
Point-to-Multipoint Architecture
Weather-proof Design
Indoor/Outdoor Architecture
Easy Installation
radio with integrated 16 dBi flat panel antenna capable to 
The DWL-1800 Wireless Outdoor Bridge series consists of 
transmitting data up to 25 km in FCC and 10km in ETSI. 
a Base Station Bridge DWL-1800B that is used to connect 
This antenna is mounted on the front cover of the Outdoor 
a single remote site or multiple remote sites to a central 
unit, which also functions as a protective sun cover.
server or Internet connection. In a multipoint configuration, 
it is the central unit; in point-to-point configurations, it 
must be installed at one end of the link. The Remote Station 
The Outdoor unit and its baseband (Ethernet) interface 
Bridge is a DWL-1800R. Up to 128 Remote Station 
cable to the Indoor unit are completely sealed for water-
Bridges can be simultaneously connected to a single Base 
proof, and can withstand extreme temperatures and harsh 
Station Bridge, forming a single wireless LAN.*
summer/winter weather. Power Over Ethernet is built in, 
allowing power to be supplied to the Outdoor unit via the 
interface cable. The Outdoor unit thus can be placed on a 
Each Base Station Bridge DWL-1800B and Remote Station 
rooftop or other where no power outlets are available.
Bridge DWL-1800R consists of an Indoor and an Outdoor 
unit. The Indoor unit supplies power, interfaces to the LAN 
inside the building through an Ethernet port, provides data 
Extensive LED diagnostics are provided, including 10-LED 
connectivity to the outdoor unit. The Outdoor unit 
RSSI bar display for easy antenna alignment. Easy 
(normally installed on rooftop) is connected the Indoor unit 
maintenance allows multiple units to be configured
through a sealed, water-proof interface cable, which can run 
and remotely upgraded. A user friendly configuration and 
up to 90 meters long. The Outdoor unit also has a front-end 
management utility is provided.
Built-in Power Over Ethernet
WiFi    compliance
Maximum sensitivity of -85 dBm at 11 Mbps
Data security with standard-based WEP encryption
Easy multiple unit remote configuration
Extensive diagnostic LEDs with 10-LED RSSI bar display
SNMP management, TFTP firmware upgradeable
Indoor Unit
Outoor Unit With Buit-in Antenna
TM
* Base Station Bridge DWL-1800B is a required product in all installations, Remote Station Bridges can only communicate with each other through DWL-1800B.