Philips PPX3614 PPX3614/F7 User Manual

You can position the device so that it lies flat on a table 
in front of the projection surface; it is not necessary to 
tilt it towards the projection surface. The device com-
pensates for the distortion from the slanted projection 
(pincushion distortion).

Electrical Voltage at the Site of Installa-
tion!
Check whether the electrical voltage of the 
power supply matches the electrical voltage 
available at the setup location.

1 Insert the small plug of the power supply into the 

socket on the rear side of your device. 

2 Plug the power supply into the power outlet.

3 During the charging process, the indicator light on 

the side of the device will be red. When the battery 
is fully charged, it will turn green.

4 Charge the built-in battery completely before using 

for the first time. This will prolong the life of the bat-
tery.

VGA

Y-Pb-Pr

HDMI

Pico Station
The battery of the Pico Station will not be 
charged while the projector is in use.

Charging via Pico Station
The battery of the projector will not be 
charged while the projector is in use.

 

Operate via Pico Station
The battery of the Pocket Projector is empty: 
Connect the Pico Station to use the Pocket 
Projector.

Battery Empty
The battery of the Pocket Projector is empty: 
Connect the Pico Station or the power supply 
to use the Pocket Projector.

Connect the power supply to the Pocket Pro-
jector or the Pico Station to recharge the bat-
tery.

Disconnect the power supply only if the 
Pocket Projector is sufficiently charged. Oth-
erwise the Pocket Projector turns off.

Risk of Explosion with Incorrect Type of 
Batteries
Only use the CR 2025 type battery.

1 To access the battery, disengage the locking mecha-

nism (

1) and slide out the battery compartment 

(

2).