Metra AX-ADXSVI-GM2 Leaflet

© COPYRIGHT 2004-2011  METRA ELECTRONICS CORPORATION 

REV

. 1/16/2014   INST

AX-ADXSVI-GM2

•  Connect the

Yellow wire to the radio’s 12 volt battery or memory wire.

•  Connect the

Black wire to the radio’s ground wire.

•  Connect the

Red wire to the ignition wire of the aftermarket radio.

•  Connect the

Orange wire to the illumination wire of the aftermarket radio. If the

aftermarket radio has no illumination wire, tape off the

Orange wire.

•  The

Orange/White wire will not be used in this application. Tape up or cap off this

wire and disregard it.

•  Connect the

Blue wire to the antenna turn on wire of the aftermarket radio.

•  Connect the

White wire to the left front positive speaker output of the aftermarket radio.

•  Connect the

White/Black wire to the left front negative speaker output of the

aftermarket radio.

•  Connect the

 Gray wire to the right front positive speaker output of the

aftermarket radio.

•  Connect the

Gray/Black wire to the right front negative speaker output of the

aftermarket radio.

•  Connect the

Green wire to the radio’s left rear positive speaker output.

•  Connect the

Green/Black wire to the radio’s left rear negative speaker output.

•  Connect the

Purple wire to the radio’s right rear positive speaker output.

•  Connect the

Purple/Black wire to the radio’s right rear negative speaker output.

Cobalt

2007-2010

HHR

2006-2011

Malibu

2008-2012

G5

2007-2008

G6

 2009

G6

2010

Solstice

2006-2009

Aura

2007-2009

Sky

2006-2009

•  Provides accessory (12 volt 10 amp)
•  Retains R.A.P. (retained accessory power)
•  Used in non-amplified systems or when replacing amplified system
•  Provides NAV outputs (parking brake, reverse, and V.S.S.)
•  Prewired ASWC-1 harness included (ASWC-1 sold separately)
•  High level speaker input
•  USB updatable

Note:
1) This harness must be used in conjunction with the AX-ADXSVI
2) All chimes will be lost when using this harness