Teleco TY2/22D User Manual
This kit consists of the following:
• Aluminium (TP3 ALU) tripod which is opened and closed like
an umbrella.
• Preassembled 65 or 80 cm dish with tiltable LNB supporting arm
• Low-noise universal LNB
• 10 m cable with connectors
• 3 pegs for locking to the ground
• Low-noise universal LNB
• 10 m cable with connectors
• 3 pegs for locking to the ground
Available models:
• cArry SAt ALU 80 with 80 cm dish
• cArry SAt ALU 65 with 65 cm dish
• The tP3ALU model tripod is also available
• cArry SAt ALU 65 with 65 cm dish
• The tP3ALU model tripod is also available
Portable satellite kit
Easy to assemble and disassemble…
And it takes up very little room when stored.
The KIT CARRY SAT was designed expressly to be assembled and
reassembled every time the vehicle is moved, or even every night. The pre-
fitted dish has an LNB boom that can be reclined and a pole fixing
bracket divided into two sections, allowing the entire kit to be stowed in
just a few seconds. All Carry Sat models can be connected to any kind of
satellite receiver. Use the FSAT1 or DSF 80 finders to facilitate pointing with
the digital receiver.
reassembled every time the vehicle is moved, or even every night. The pre-
fitted dish has an LNB boom that can be reclined and a pole fixing
bracket divided into two sections, allowing the entire kit to be stowed in
just a few seconds. All Carry Sat models can be connected to any kind of
satellite receiver. Use the FSAT1 or DSF 80 finders to facilitate pointing with
the digital receiver.
It is provided with a
rotating top section
for easier dish
tracking.
DSF 80
Finder with 8
satellites and
Signal Level Indicator.
Compatible with all
manual satellite systems.
Finder with 8
satellites and
Signal Level Indicator.
Compatible with all
manual satellite systems.
DSF 80/E
Finder with 8
satellites, Signal
satellites, Signal
Level Indicator and
Electronic Dish Elevation
Indicator. This model can
only be used on Voyager Matic
and Voyager Digimatic systems - equipped with a
special Electronic Angle Detector system.
Electronic Dish Elevation
Indicator. This model can
only be used on Voyager Matic
and Voyager Digimatic systems - equipped with a
special Electronic Angle Detector system.
Digital Satellite precision finders
User’s instructions:
1) Select the required satellite (e.g. ASTRA 19E )
2) Raise the dish to the relevant elevation for the current
location of the vehicle (see the Angle map)
3) Turn the dish SOUTHWARDS until DSF80/E emits a
continuous "BEEP" sound.
4) Wait for the SAT OK diode (LED) to light up, confirming
that the located satellite is the required one.
2) Raise the dish to the relevant elevation for the current
location of the vehicle (see the Angle map)
3) Turn the dish SOUTHWARDS until DSF80/E emits a
continuous "BEEP" sound.
4) Wait for the SAT OK diode (LED) to light up, confirming
that the located satellite is the required one.
5) If a different satellite has been found, the SAT NOT OK LED
will light up and the dish must be rotated again until the
"BEEP" sound is heard again and the SAT OK LED lights up.
6) Optimise pointing by slowly adjusting both dish elevation
and dish rotation, until the maximum number of lit LEDs is
obtained on the LEVEL indicator.
will light up and the dish must be rotated again until the
"BEEP" sound is heard again and the SAT OK LED lights up.
6) Optimise pointing by slowly adjusting both dish elevation
and dish rotation, until the maximum number of lit LEDs is
obtained on the LEVEL indicator.
19