APC AP95100 Power supplier AP95100 User Manual

Use the Motion Sensitivity Mask to configure the Camera Motion sensor to ignore movement that is 
detected in specified regions of the image capture. To mask a portion of the image, click and drag in the 
image to draw a box around the region you want to ignore. Then click Mask Selection to mask the 
selected region. Red X’s will appear in the region of the image in which movement will be ignored.

To unmask a portion of a previously masked region, click and drag in the image to draw a box around the 
region you want to unmask. Then, click Unmask Selection to remove the mask from the selected region. 
Any red X’s that were displayed in the selected region will then be removed.

When you are finished, click OK and any changes you have made will be saved to the selected devices. 
Click Cancel to close the Camera Masking task without saving any changes.

The following controls are available on the Block Out Mask tab:

Use the Block Out Mask to configure the cameras of selected devices so that specified areas of the image 
cannot be seen. For example, you could place a Block Out Mask over the area of the image that shows a 
monitor image, thereby preventing users from seeing the information that is shown on the monitor. 
Instead, a gray box will appear in the masked area. 

To mask a portion of the image, click and drag in the image to draw a box around the region you want to 
ignore. Then right-click and select Mask Selection to mask the selected region. A blue block will appear 
in the region of the image to be blocked.

To unmask a portion of a previously masked region, click and drag in the image to draw a box around the 
region you want to unmask. Then, click Unmask Selection to remove the mask from the selected region. 
Any portion of the blue block out mask that you selected will then be removed.

When you are finished, click OK and any changes you have made will be saved to the device. Click 
Cancel to close the Camera Masking task without saving any changes.

Show outline of detected motion 
check box 

When this option is enabled, any region of an image captured by 
the device that is determined to be indicative of motion is 
surrounded by a dotted-line outline. Note that if this option is 
enabled then the dotted-line outline will appear in the camera 
image that is displayed in the Sensor Pane as well.

Motion Sensitivity Mask

Use the Motion Sensitivity Mask to specify regions of the image 
that will be ignored by the Camera Motion sensor.

Enable Block Out Mask check box

Check this check box to enable the Block Out Mask 
functionality.

Block Out Mask

Use the Block Out Mask to specify regions of the image that will 
not be visible when the camera image is viewed.