APC AP95100 Power supplier AP95100 User Manual

c. If you are using a port other than port 80 for device network communications, type in the Port 

field the port number in use. 

d. Type in the User ID field apc2.

e. Type in the Password field apc2.

f. Click OK to save this configuration.

3. Click the X in the upper right-hand corner of the window to close the Device Security Settings 

window.

InfraStruXure Central can automatically search a user-specified IP address range on your network for 
supported management and SNMP devices. If new devices are discovered, InfraStruXure Central will 
add them to the All Devices device group. Later, when you have defined additional device groups, 
discovered devices will be automatically added to any appropriate device groups. Before devices can be 
discovered, however, you must configure the InfraStruXure Central Discovery Settings.

To start the Discovery Settings task, select from the Tools pull-down menu Server Administration > 
Discovery Settings.

For this example, we will assume you have management devices installed in the 192.168.1.* and 
192.168.2.* subnets of your network, that all of the management devices on subnet 192.168.1.* are 
configured to use port 80 for network communications, that all of the management devices on subnet 
192.168.2.* are configured to use port 100 for network communications, and that you want to discover 
management devices each Sunday at 5:00PM.

1. Click Create and then create a discovery configuration for devices on the 192.168.1.* subnet.

a. The Create Discovery Entry opens.

b. Select the Management device radio button and then click Next.

c. Type in the IP Range field 192.168.1.*.

d. Type in the Port Range field 80.

e. Specify SSL Options. By default, Do not use SSL is selected. If desired, you can configure the 

Discovery Settings to use SSL if available, require SSL without verification, or require SSL with 
verification.

f. Check the Enable schedule check box. If discovery is not enabled, the discovery settings are 

saved but no discovery functions are actually carried out.

g. Click Sunday in the Days check boxes. This is the day of the week the discovery process will 

run.

h. Use the Time controls to specify 5:00 PM. This is the time of day the discovery process will run.

i. Click Finish to save this configuration.

2. Click Create and then create a Discovery configuration for devices on the 192.168.2.* subnet.

a. The Create Discovery Entry opens.

Obviously this probably does not accurately reflect your particular device configuration, 
but this example should provide you with a working understanding of the Discovery 
Settings task so that you can create discovery configurations that fit your needs.