Manualsbrain.com
  1. Manuals
  2. Brands
  3. Extreme networks
  4. SX mini-GBIC module
  5. Leaflet

Extreme networks SX mini-GBIC module 10051 Leaflet

Product codes
10051
Download
Page of 2
Part Number: 100099-00 Rev 02
1
Mini-Gigabit Interface Connector 
(Mini-GBIC) Installation Note
You can add and remove mini-GBICs from your Extreme Networks switch without powering 
off the system. There are two types of mini-GBIC interfaces: the LX mini-GBIC, which conforms 
to the 1000BASE-LX standard, and the SX mini-GBIC, which conforms to the 1000BASE-SX 
standard. The mini-GBIC connector, which is shown in Figure 1, is the same for both types of 
mini-GBIC interfaces.
Figure 1: Mini-GBIC module
Mini-GBICs are a Class 1 laser device. Use only Extreme-approved devices.
Remove the LC fiber-optic connector from the mini-GBIC prior to removing the 
mini-GBIC from the port.
 Mini-GBICs can emit invisible laser radiation. Avoid direct eye exposure to beam.
If you see an amber blinking mini-GBIC port status LED on your Extreme Networks 
switch or you receive an error message when you install a non-Extreme-supported 
mini-GBIC, you do not have an Extreme-supported mini-GBIC installed in your switch. To 
correct this problem, make sure you install an Extreme-supported mini-GBIC into the port 
on the switch.
To remove the mini-GBIC connector, gently push in the plastic tab at the bottom of the 
connector and pull the mini-GBIC out of the port on the switch.
To insert a mini-GBIC connector:
1
Holding the mini-GBIC by its sides, insert the mini-GBIC into the port on the switch.
2
Slide the mini-GBIC into the port, until you hear it click.
XM_032