Hameg HZO50Clip-on ammeter adapter 17-O050-0000 Data Sheet

Product codes

17-O050-0000

HZO10/20/30/50/51E/240112 · C&E · Subject to change without notice · © HAMEG Instruments GmbH

· DQS-certified in accordance with DIN EN ISO 9001:2008, Reg.-No.: 071040 QM08

HAMEG Instruments GmbH · Industriestr. 6 · D-63533 Mainhausen · Tel +49 (0) 6182 8000 · Fax +49 (0) 6182 800100 · www.hameg.com · info@hameg.com

This AC/DC current probe is used to measure currents from 1 mA
to 30 A over a broad frequency range. The measure ment principle is
based on the Hall Effect that registers the magnetic field generated
by the current flow. Even for complex waveforms a high degree of
measurement accu racy is achieved. The output voltage is propor-
tional to the measured current and well suited to be displayed on
an oscilloscope. The current probe complies with the safety stand-
ards defined in IEC/EN 61010.

Specifications

Measurement range:

±20 A

rms

/30 A

Accuracy:

±1 % from measurement value ±2 mA

Bandwidth:

DC…100 kHz (0.5 dB)

Resolution:

±1 mA

Output Voltage:

100 mV/A

Load impedance:

>100 kΩ II ≤100 pF

Max. Voltage:

300 V

rms

(AC or DC)

Output cable/Connector: 2 m (50 Ω)/BNC

Measuring category:

CAT III

H Z O 5 0 A C / D C C u r r e n t P r o b e 3 0 A

This AC/DC current probe is used to measure currents from 100 mA
to 1000 A over a broad frequency range. The measure ment prin-
ciple is based on the Hall Effect that registers the magnetic field

generated by the current flow. Even for complex waveforms a high
degree of measurement accu racy is achieved. The output voltage
is proportional to the measured current and well suited to be dis-
played on an oscilloscope. The current probe complies with the

safety standards defined in IEC/EN 61010.

Specifications

Measurement range:

±100 A

rms

/1000 A

rms

Accuracy:

±1 % from measurement value ±0.1 A/±0.5 A

Bandwidth:

DC…20 kHz