TP-LINK CPE510 User Manual
Chapter 7 Management Tab
RSSI LED Thresholds
You can configure the LEDs on the device to light up when received signal levels reach the values defined
in the following fields. This allows a technician to easily deploy a Pharos series product without logging
into the device (for example, for antenna alignment operation).
in the following fields. This allows a technician to easily deploy a Pharos series product without logging
into the device (for example, for antenna alignment operation).
Thresholds (dBm)
The specified LED will light up if the signal strength reaches the values in the
field. For example, if the signal strength fluctuates around -63 dBm, then the
LED threshold values can be set to the following: -70, -65, -62, and -60. The
default values are set according to the verified optimum values. We
recommend you keep it by default.
The default LED threshold values may vary among different product models in
terms of radio features. The figure above shows the default values of CPE210.
field. For example, if the signal strength fluctuates around -63 dBm, then the
LED threshold values can be set to the following: -70, -65, -62, and -60. The
default values are set according to the verified optimum values. We
recommend you keep it by default.
The default LED threshold values may vary among different product models in
terms of radio features. The figure above shows the default values of CPE210.
- 76 -