Texas Instruments TPS62366AEVM-757 Evaluation Module TPS62366AEVM-757 TPS62366AEVM-757 Data Sheet
Product codes
TPS62366AEVM-757
Setup
2.1.9
J9 – I
2
C Monitor Point and Alternate Connection
This header is provided to connect to or monitor the I
2
C signals on the TPS62366AEVM-757. If the I
2
C
signals are being sent via this header (and not via the USB-TO-GPIO adaptor), do not plug into the J8
header and provide a separate V
header and provide a separate V
DD
supply on JP1 without any jumper installed.
2.1.10
J10 – Load Step Signal Input
This SMA connector accepts a signal input from a function generator that drives Q1 in order to evaluate
the TPS62366A's transient response. Since this connector is not installed, TP4 can be used for the same
function.
the TPS62366A's transient response. Since this connector is not installed, TP4 can be used for the same
function.
2.1.11
JP1 – V
DD
Control
This jumper is used to connect V
DD
to either a 3.3V rail provided by the USB-TO-GPIO adaptor (jumper
across pins 1 and 2) or to GND to reset the I
2
C registers (jumper across pins 2 and 3). Alternatively, the
user can provide their own V
DD
voltage (1.15 - 3.6V) between pins 2 and 3 of JP1. No jumper should be
installed in this case. For normal operation without an external supply voltage, the jumper should be
installed between pins 1 and 2.
installed between pins 1 and 2.
2.1.12
JP2 – VSEL
This jumper sets the VSEL pin to either a logic high (jumper across pins 1 and 2) or a logic low (jumper
across pins 2 and 3).
across pins 2 and 3).
2.1.13
JP3 – EN
This jumper sets the EN pin to either a logic high (jumper across pins 1 and 2) or a logic low (jumper
across pins 2 and 3). When EN is low, the TPS62366A output will be off and not switching. Set EN to high
to turn on the output voltage.
across pins 2 and 3). When EN is low, the TPS62366A output will be off and not switching. Set EN to high
to turn on the output voltage.
2.2
Software Setup
The software is available at the TI website,
Download and unzip the file. Run setup.exe and follow the on screen instructions to complete the
installation.
installation.
NOTE:
The installation page is best viewed with Microsoft Internet Explorer browser (it may not work
correctly with other browsers).
The Microsoft .Net Framework 2.0 is required for the software to run.
After installation, the software should automatically run. To run the software later, go to
Start
→
All Programs
→
Texas Instruments
→
TPS62366x EVM
→
TPS62366x EVM.
During future use of the software, it may prompt you to install a new version if one becomes available on
the Web.
the Web.
NOTE:
VeriSign™ Code Signing is used to prevent any malicious code from changing this
application. If at any time in the future the binaries are modified, the code will no longer
attempt to run.
attempt to run.
2.3
Hardware Setup
shows the default jumper settings.
4
TPS62366AEVM-757
SLVU690 – April 2012
Copyright © 2012, Texas Instruments Incorporated