Manualsbrain.com
  1. Manuals
  2. Brands
  3. Atmel
  4. Xplained Pro Evaluation Kit ATSAM4E-XPRO
  5. Data Sheet

Atmel Xplained Pro Evaluation Kit ATSAM4E-XPRO ATSAM4E-XPRO Data Sheet

Product codes
ATSAM4E-XPRO
Download
Page of 24
 
Atmel SAM4E Xplained Pro [USER GUIDE]
42216A-MCU-01/2014
8
Xplained Pro extensions to Xplained Pro MCU boards and to access the pins of the target MCU on Xplained
Pro MCU board directly.
Table 3-4. Xplained Pro Extension Header
Pin number
Name
Description
1
ID
Communication line to the ID chip on extension board.
2
GND
Ground.
3
ADC(+)
Analog to digital converter , alternatively positive part of
differential ADC.
4
ADC(-)
Analog to digital converter , alternatively negative part of
differential ADC.
5
GPIO1
General purpose I/O.
6
GPIO2
General purpose I/O.
7
PWM(+)
Pulse width modulation , alternatively positive part of
differential PWM.
8
PWM(-)
Pulse width modulation , alternatively positive part of
differential PWM.
9
IRQ/GPIO
Interrupt request line and/or general purpose I/O.
10
SPI_SS_B/GPIO
Slave select for SPI and/or general purpose I/O.
11
TWI_SDA
Data line for two-wire interface. Always implemented, bus
type.
12
TWI_SCL
Clock line for two-wire interface. Always implemented, bus
type.
13
USART_RX
Receiver line of Universal Synchronous and Asynchronous
serial Receiver and Transmitter.
14
USART_TX
Transmitter line of Universal Synchronous and
Asynchronous serial Receiver and Transmitter.
15
SPI_SS_A
Slave select for SPI. Should be unique if possible.
16
SPI_MOSI
Master out slave in line of Serial peripheral interface. Always
implemented, bus type.
17
SPI_MISO
Master in slave out line of Serial peripheral interface. Always
implemented, bus type.
18
SPI_SCK
Clock for Serial peripheral interface. Always implemented,
bus type.
19
GND
Ground.
20
VCC
Power for extension board.
3.4.2
Xplained Pro LCD Connector
The LCD connector provides the ability to connect to display extensions that have a parallel interface. The
connector implements signals for a MCU parallel bus interface and a LCD controller interface as well as
signals for a touchcontroller. The connector pin-out definition is shown in 
the MCU bus interface.
A FPC/FFC connector with 50 pins and 0.5mm pitch is used for the LCD connector. The connector
(XF2M-5015-1A) from Omron is used on several designs and can be used as a reference.
Table 3-5. Xplained Pro LCD Connector
Pin number
Name
RGB interface
description
MCU interface
description
1
ID
Communication line to ID chip on extension board.
2
GND
Ground
3
D0
Data line