Atmel MCU Evaluation Kit AT32UC3L-EK AT32UC3L-EK Data Sheet
Product codes
AT32UC3L-EK
26
Atmel AVR32025
32150B-AVR-03/12
Figure 3-18. Atmel AT32UC3L-EK bottom view USB interface location.
3.7.2 Schematics
In Section
,
, the USB interface block is
described on page 6.
3.7.3 UC3L-specific information
3.7.3.1 Atmel T32UC3L064 pinout for the USB interface block
Table 3-18. UC3L pinout for the USB interface block.
QFP48 pin
GPIO
GPIO alternate functions
Feature
6 PB00
USART3.TXD
USART3
TX
line
16
PB01
USART3.RXD
USART3 RX line
3.7.4 Configuration and test points
3.7.4.1 AT32UC3LB1256 default firmware configuration
The default firmware pre-loaded on the Atmel AT32UC3B1256 is dynamically
configurable upon power up:
configurable upon power up:
• The USB DFU boot loader can be enabled by closing the J12 jumper. Use
flip/batchisp to read/write resources on the AT32UC3B1256 through the boot
loader
loader
IMPORTANT
Programming the AT32UC3B1256 will overwrite the default firmware.
• If the USB MODE pushbutton is pressed at power up, the USB virtual com port
firmware will execute. Otherwise, the USB HID QTouch Debug firmware will
execute
execute
3.7.4.2 Test points
A few test points covering the USB interface block have been placed on the Atmel
AT32UC3L-EK for the verification of important signals.
AT32UC3L-EK for the verification of important signals.
J13
UC3B