Atmel SAM4L Xplained Pro Evaluation Kit Atmel ATSAM4L-XPRO ATSAM4L-XPRO Data Sheet
Product codes
ATSAM4L-XPRO
Atmel SAM4L Xplained Pro [USER GUIDE]
42074B-MCU-05/2013
8
Data Field
Data Type
Example Content
Minimum Voltage [mV]
uint16_t
3000
Maximum Voltage [mV]
uint16_t
3600
Maximum Current [mA]
uint16_t
30
3.3
Power supply
The SAM4L Xplained Pro kit can be powered either by USB or by an external power source through the 4-
Table 3-3. Power sources for SAM4L Xplained Pro
Power input
Voltage requirements
Current requirements
Connector marking
External power
5V +/- 2 % (+/- 100mV)
for USB host operation.
4.3 V to 5.5 V if USB
4.3 V to 5.5 V if USB
host operation is not
required
Recommended
minimum is 1A to
be able to provide
enough current for
connected USB
devices and the board
itself. Recommended
maximum is 2A due
to the input protection
maximum current
specification.
PWR
Embedded debugger
USB
4.4V to 5.25V
(according to USB spec)
500 mA (according to
USB spec)
DEBUG USB
Target USB
4.4V to 5.25V
(according to USB spec)
500 mA (according to
USB spec)
TARGET USB
The kit will automatically detect which power sources are available and choose which one to use according to
the following priority:
1. External power
2. Embedded debugger USB
3. Target USB
Note
External power is required when the 500mA through the USB connector is not enough to power a
connected USB device in a USB host application.
3.3.1
Measuring SAM4L power consumption
As part of an evaluation of the SAM4L it can be of interest to measure its power consumption. Because the
device has a separate power plane (VCC_MCU_P3V3) on this board it is possible to measure the current
consumption by measuring the current that is flowing into this plane. The VCC_MCU_P3V3 plane is connected
via a jumper to the main power plane (VCC_TARGET_P3V3) and by replacing the jumper with an ampere
meter it is possible to determine the current consumption. To locate the current measurement header, please
refer to
.
Warning
Do not power the board without having the jumper or an ampere meter mounted. This can cause
the SAM4L to be powered through its I/O pins and cause undefined operation of the device.
3.4
Standard Headers and Connectors
3.4.1
Xplained Pro extension header
All Xplained Pro kits have one or more dual row, 20 pin, 100mil extension headers. Xplained Pro MCU boards
have male headers while Xplained Pro extensions have their female counterparts. Note that all pins are