Atmel Evaluation Kit AT91SAM9X25-EK AT91SAM9X25-EK Data Sheet
Product codes
AT91SAM9X25-EK
664
SAM9X25 [DATASHEET]
11054E–ATARM–10-Mar-2014
35.7.2 Data Transfer
Four combinations of polarity and phase are available for data transfers. The clock polarity is programmed with the CPOL
bit in the Chip Select Register. The clock phase is programmed with the NCPHA bit. These two parameters determine
the edges of the clock signal on which data is driven and sampled. Each of the two parameters has two possible states,
resulting in four possible combinations that are incompatible with one another. Thus, a master/slave pair must use the
same parameter pair values to communicate. If multiple slaves are used and fixed in different configurations, the master
must reconfigure itself each time it needs to communicate with a different slave.
bit in the Chip Select Register. The clock phase is programmed with the NCPHA bit. These two parameters determine
the edges of the clock signal on which data is driven and sampled. Each of the two parameters has two possible states,
resulting in four possible combinations that are incompatible with one another. Thus, a master/slave pair must use the
same parameter pair values to communicate. If multiple slaves are used and fixed in different configurations, the master
must reconfigure itself each time it needs to communicate with a different slave.
shows the four modes and corresponding parameter settings.
show examples of data transfers.
Figure 35-3. SPI Transfer Format (NCPHA = 1, 8 bits per transfer)
Table 35-4. SPI Bus Protocol Mode
SPI Mode
CPOL
NCPHA
Shift SPCK Edge
Capture SPCK Edge
SPCK Inactive Level
0
0
1
Falling
Rising
Low
1
0
0
Rising
Falling
Low
2
1
1
Rising
Falling
High
3
1
0
Falling
Rising
High
6
*
SPCK
(CPOL = 0)
SPCK
(CPOL = 1)
MOSI
(from master)
MISO
(from slave)
NSS
(to slave)
SPCK cycle (for reference)
MSB
MSB
LSB
LSB
6
6
5
5
4
4
3
3
2
2
1
1
* Not defined, but normally MSB of previous character received.
1
2
3
4
5
7
8
6