Atmel SAM4L Xplained Pro Starter Kit Atmel ATSAM4L-XSTK ATSAM4L-XSTK Data Sheet

Product codes
ATSAM4L-XSTK
Page of 173
98
42023ES–SAM–07/2013
ATSAM4L8/L4/L2
9.
Electrical Characteristics
9.1
Absolute Maximum Ratings*
9.2
Operating Conditions
All the electrical characteristics are applicable to the following conditions unless otherwise spec-
ified :
– operating voltage range 1,68V to 3,6V for VDDIN, VDDIO & VDDANA
– Power Scaling 0 and 2 modes
– operating temperature range: TA = -40°C to 85°C and for a junction temperature up 
to TJ = 100°C. 
Typical values are base on TA = 25°c and VDDIN,VDDIO,VDDANA = 3,3V unless otherwise
specified
9.3
Supply Characteristics
 
Refer to 
 for details about Power
Supply
Table 9-1.
Absolute Maximum Ratings
Operating temperature..................................... -40
°
C to +85
°
C
*NOTICE:
Stresses beyond those listed under “Absolute Maxi-
mum Ratings” may cause permanent damage to the
device. This is a stress rating only and functional
operation of the device at these or other conditions
beyond those indicated in the operational sections of
this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may
affect device reliability.
Storage temperature...................................... -60°C to +150°C
Voltage on input pins
with respect to ground ..........................-0.3V to  V
VDD
 (1)
+0.3V
1.
V
VDD
 corresponds to either V
VDDIN
 or V
VDDIO
, depending on the supply for the pin. Refer to 
 for details
Total DC output current on all I/O pins
VDDIO ......................................................................... 120 mA
Total DC output current on all I/O pins
VDDIN ........................................................................ 100 mA
Total DC output current on all I/O pins
VDDANA ........................................................................ 50 mA
Maximum operating voltage VDDIO, VDDIN .................... 3.6V
Table 9-2.
Supply Characteristics
Symbol
Conditions
Voltage
Min
Max
Unit
V
VDDIO,
V
VDDIN,
V
VDDANA
PS1 (FCPU<=12MHz)
Linear mode
1.68
3.6
V
PS0 & PS2 (FCPU>12MHz)
Linear mode
1.8
Switching mode
2.0
 (1)
1.
Below 2.3V, linear mode is more power efficient than switching mode.