Atmel SAM4L Xplained Pro Starter Kit Atmel ATSAM4L-XSTK ATSAM4L-XSTK Data Sheet
Product codes
ATSAM4L-XSTK
663
42023E–SAM–07/2013
ATSAM4L8/L4/L2
26. Serial Peripheral Interface (SPI)
Rev: 2.1.1.3
26.1
Features
•
Compatible with an embedded 32-bit microcontroller
•
Supports communication with serial external devices
– Four chip selects with external decoder support allow communication with up to 15
peripherals
– Serial memories, such as DataFlash and 3-wire EEPROMs
– Serial peripherals, such as ADCs, DACs, LCD controllers, CAN controllers and Sensors
– External co-processors
•
Master or Slave Serial Peripheral Bus Interface
– 4 - to 16-bit programmable data length per chip select
– Programmable phase and polarity per chip select
– Programmable transfer delays between consecutive transfers and between clock and data
per chip select
– Programmable delay between consecutive transfers
– Selectable mode fault detection
•
Connection to Peripheral DMA Controller channel capabilities optimizes data transfers
– One channel for the receiver, one channel for the transmitter
– Next buffer support
– Four character FIFO in reception
26.2
Overview
The Serial Peripheral Interface (SPI) circuit is a synchronous serial data link that provides com-
munication with external devices in Master or Slave mode. It also enables communication
between processors if an external processor is connected to the system.
munication with external devices in Master or Slave mode. It also enables communication
between processors if an external processor is connected to the system.
The Serial Peripheral Interface is essentially a shift register that serially transmits data bits to
other SPIs. During a data transfer, one SPI system acts as the “master”' which controls the data
flow, while the other devices act as “slaves'' which have data shifted into and out by the master.
Different CPUs can take turn being masters (Multiple Master Protocol opposite to Single Master
Protocol where one CPU is always the master while all of the others are always slaves) and one
master may simultaneously shift data into multiple slaves. However, only one slave may drive its
output to write data back to the master at any given time.
other SPIs. During a data transfer, one SPI system acts as the “master”' which controls the data
flow, while the other devices act as “slaves'' which have data shifted into and out by the master.
Different CPUs can take turn being masters (Multiple Master Protocol opposite to Single Master
Protocol where one CPU is always the master while all of the others are always slaves) and one
master may simultaneously shift data into multiple slaves. However, only one slave may drive its
output to write data back to the master at any given time.
A slave device is selected when the master asserts its NSS signal. If multiple slave devices
exist, the master generates a separate slave select signal for each slave (NPCS).
exist, the master generates a separate slave select signal for each slave (NPCS).
The SPI system consists of two data lines and two control lines:
• Master Out Slave In (MOSI): this data line supplies the output data from the master shifted
into the input(s) of the slave(s).
• Master In Slave Out (MISO): this data line supplies the output data from a slave to the input of
the master. There may be no more than one slave transmitting data during any particular
transfer.
transfer.
• Serial Clock (SPCK): this control line is driven by the master and regulates the flow of the
data bits. The master may transmit data at a variety of baud rates; the SPCK line cycles once
for each bit that is transmitted.
for each bit that is transmitted.
• Slave Select (NSS): this control line allows slaves to be turned on and off by hardware.