Carson 1:8 RC model car Nitro Buggy 500204029 User Manual

Always turn the radio on before turning your car on.

 

Now you can 

switch on your car using the on/off switch located on the radio box. 
Note: Always check your radio settings before running your car!

Check to make sure your steering is centred. If it is not, use the ST-TRIM 
knob to the left of the steering wheel. Turning left should make the car 
turn left. Right = right.

Now it’s time to set the throttle neutral position. Remove the air 
cleaner from the carburettor. 

The opening on the carb slide should be open very little, from 
1-1.5 mm to allow the engine to idle (picture 2). If it is open more than 
this, the engine may rev higher than normal until brakes are applied. 
This condition may wear out the brakes and/or clutch shoes 
prematurely making the car difficult to drive. 

Use the TH-TRIM tab (picture 3) to move the servo arm into the neutral 
position if necessary. While in neutral, the brakes should not be set 
to “drag”. Adjusting the collars with a 1.5 mm hexagonal wrench will 
change your drag brake settings. Replace the air cleaner when 
everything is adjusted to your satisfaction.

Assemble the fuel bottle. Fill the fuel bottle by compressing it and then 
insert the spout into the fuel. Allow the bottle to decompress and the 
suction will fill the fuel bottle. Fill the tank by gently squeezing the 
bottle and ensure that the tank lid is firmly shut when finished.

Fuel will stay fresh longer if you store it in a cool, dark and dry place.

Never leave the glow heater on your engine for more than 10 seconds. 
A longer time may cause the glow plug to burn out prematurely. Use 
rechargeable glow heaters for longer life. 

To start the motor, use a fireproof glove!

1 - 1,5 mm