ECX Brushed 1:10 RC model car Electric Short co ECX03026 User Manual

TORMENT

®

Solid Green: Battery 
voltage is good (above 
4V).

Flashing Green: Battery 
voltage is critically low 
(below 4V). Replace 
batteries.

Adjusts the neutral point 
of the electronic speed 
control.

Adjust to make the vehicle 
drive straight with no input 
at the steering wheel.

Power on 
or off the 
transmitter.

Control steering. Right and 
Left steering with ST. REV 
Switch on N
(see ST. REV switch).

Controls power to motor for forward 
or reverse (see TH. REV switch).

Stop

Reverse 

(when TH. 

REV switch 

on R).

Forward 
(when TH. 
REV switch on R).

Adjusts the amount the 
front wheels move when the 
steering wheel is turned left 
or right.

Allows you to change the 
direction of steering  (ST. REV) 
and throttle (TH. REV) controls 
(default settings are “N” for 
steering and “R” for throttle).

The travel function supports precise endpoint adjustments in 
each direction for the steering and throttle channels.
1. Hold the trigger in the full brake position while powering 

on the transmitter. The LED flashes rapidly, indicating the 
programming mode is active.

2. Throttle End Point: Hold the trigger in the full throttle position. 

Turn the TH TRIM knob to adjust the full throttle end point.

3. Brake End Point: Hold the trigger in the full brake position. 

Turn the TH TRIM knob to adjust the full brake end point. 
Return the trigger to the center position.

4. Left Steering End Point: Hold the steering wheel in the full left 

position. Turn the ST TRIM knob to adjust the left end point.

5. Right Steering End Point: Hold the steering wheel in the full 

right position. Turn the ST TRIM knob to adjust the right end 
point. Return the steering wheel to the center position.

6. Power off the transmitter to save the travel adjust settings. 

The minimum Travel is 75%, and the Maximum travel is 
150%. The default travel settings are 125% steering and 
100% throttle.