Conrad Thermostat Variable Temperature Switch Kit With Sensor 192082 Data Sheet
Product codes
192082
•
The device can be damaged, if a liquid penetrates in it. In case you have spilt
any liquid in or over the assembly, then get the device checked by a qualified
expert.
any liquid in or over the assembly, then get the device checked by a qualified
expert.
Intended use
The intended use of the device is the switching of electrical consumers if a
previously set temperature is fallen short of or exceeded.
A use other than the intended one is not permitted!
previously set temperature is fallen short of or exceeded.
A use other than the intended one is not permitted!
Safety instructions
While handling the products that come in contact with electrical voltage the valid
VDE-guidelines must be observed, especially VDE 0100, VDE 0550/0551, VDE
0700, VDE 0711 and VDE 0860.
VDE-guidelines must be observed, especially VDE 0100, VDE 0550/0551, VDE
0700, VDE 0711 and VDE 0860.
•
Before opening the device always pull out the plug or make sure that the
device is completely without current.
device is completely without current.
•
Components, assemblies or devices may be started up only when they have
been fitted, completely insulated, in a casing. While fitting they must be
completely devoid of current.
been fitted, completely insulated, in a casing. While fitting they must be
completely devoid of current.
•
Tools may be used on devices, components or assemblies only when is has
been ensured that the devices have been disconnected from the power
supply and electrical charges on the components present in the devices have
been discharged.
been ensured that the devices have been disconnected from the power
supply and electrical charges on the components present in the devices have
been discharged.
•
Live cables or lines, which are connected to the device, component or
assembly, must always be checked for insulation faults or breaks.
assembly, must always be checked for insulation faults or breaks.
If a fault is ascertained in the supply line, the device must immediately be taken
out of service till the defective cable has been replaced.
out of service till the defective cable has been replaced.
•
When using electronic components or assemblies, the strict adherence to the
characteristics for electrical variables given in the description must always be
indicated.
characteristics for electrical variables given in the description must always be
indicated.
•
If the given description for the non-commercial end-user is not clear about the
electrical characteristics applicable for the component or assembly, about
how an external wiring is to be done or which external components or
auxiliary equipment may be connected and what connected values these
external components may have, then the required information must always be
obtained from an expert.
electrical characteristics applicable for the component or assembly, about
how an external wiring is to be done or which external components or
auxiliary equipment may be connected and what connected values these
external components may have, then the required information must always be
obtained from an expert.
•
Before commissioning a device it must always be checked in general,
whether this device or assembly is suitable for the application, for which it is
intended to be used!
whether this device or assembly is suitable for the application, for which it is
intended to be used!
In cases of doubt, please always ask the experts, the responsible persons or the
manufacturer of the devices or assemblies used!
manufacturer of the devices or assemblies used!