Conrad 16-Channel Running Light Controller Module 190486 Data Sheet

The 16 channel running light control is an electronics board ready for operation, which is able
to control up to 16 LEDs or LED groups to enable several running light functions.
At delivery, the device already has 17 different light sequences and one automatic programme
stored. In automatic mode, the different light sequences run for approx. 6 seconds each before
the programme switches to the next light sequence.
The respective light sequence to be started with after connecting operating voltage can be set
and stored individually. The running light speed can be set in 26 stages.
The board can be operated either as a “stand alone” device or in “RC” mode.
In “Stand alone” mode, the different running light sequences are switched or selected by
pressing buttons on the module.
In “RC” mode, a free receiver channel can be used to switch the running light function via
remote control transmitter. Additionally, the “RV” mode also has 4 switchable outputs for
special functions.
The 16 channel running light control programming (Open Source C-Control Pro Programme)
can be adjusted individually for the model if required. www.c-control.de offers a free-of-charge
programming interface for this.
The electronics are not protected against moisture and other environmental influences. When
used in a model plane or model vehicle, it must be installed inside the model.
The inputs and outputs are designed with common soldering contacts to which connection
cables or 2.54mm pin bars can be soldered.