Conrad 16-Channel Running Light Controller Module 190486 Data Sheet

For proper function, the 16-channel running light control must be connected to the drive battery
of a model or, in stationary operation, with a mains adapter. For this, solder two connection
lines to the left side of the board, at the solder points “UB” (+) and “GND” (-).



The 16-channel running light control may be used at a voltage of 5 to 18 V/DC.
In model construction practice, it has turned out to be beneficial to supply the 16-
channel running light control via the balancer plug of a 2-4-cell LiPo battery. In this
case, the power supply lines must be equipped with a suitable plug connector (like
on the balancer connection of the charger). Only the two outer plug contacts are
then used for connection.