Conrad 16-Channel Running Light Controller Module 190486 Data Sheet
Product codes
190486
33
In “RC” mode, the running light function and switching channels are first deactivated.
Depending on the operation direction of the controller at the transmitter, you can now switch
on or change the running light sequences or operate the 4 switching channels (S1 to S4). Every
time the switch is operated, a switching channel is switched on; at the fifth operation of the
switch, all 4 switching channels are switched off again together.
The central position of the switch should correspond to an impulse width of 1.5 ms at the RC
input. At a value of more than 1.8 ms, the electronics switches the running light function and
at a value of less than 1.2 ms, the switching channels are switched.
This has the advantage that you will start an unlighted model and then will be able to switch
on the different light functions and the running lights during the model drive to the joy of your
audience.
Depending on the operation direction of the controller at the transmitter, you can now switch
on or change the running light sequences or operate the 4 switching channels (S1 to S4). Every
time the switch is operated, a switching channel is switched on; at the fifth operation of the
switch, all 4 switching channels are switched off again together.
The central position of the switch should correspond to an impulse width of 1.5 ms at the RC
input. At a value of more than 1.8 ms, the electronics switches the running light function and
at a value of less than 1.2 ms, the switching channels are switched.
This has the advantage that you will start an unlighted model and then will be able to switch
on the different light functions and the running lights during the model drive to the joy of your
audience.
b) Commissioning in “Stand alone” Mode
If you operate the running light control in “Stand alone” mode, the RC input must be
connected to earth/GND for a consistent running light speed.
connected to earth/GND for a consistent running light speed.
Connect the power supply to the 16-channel running light control.
In the “Stand alone” mode, the running light function starts right when the operating voltage is
applied. Press the mode button SW 2 to switch between the different light sequences of the
running light.
In the “Stand alone” mode, the running light function starts right when the operating voltage is
applied. Press the mode button SW 2 to switch between the different light sequences of the
running light.
Attention!
The voltage stabiliser U1 may grow warm or hot depending on operating voltage
applied. When pressing the button SW 2, make sure not to touch the stabiliser U1
with unprotected fingers.
The voltage stabiliser U1 may grow warm or hot depending on operating voltage
applied. When pressing the button SW 2, make sure not to touch the stabiliser U1
with unprotected fingers.