Renkforce 3D printer RF1000 Single extruder (value.974113) RF1000 Data Sheet
Product codes
RF1000
. Explanation of Symbols
The symbol with a lightning bolt in a triangle is used where there is a health hazard, e.g. from electric shock. The device
contains no parts that require servicing by the user. Therefore, never open the device.
The exclamation mark symbol indicates that the user must read these operating instructions before commissioning of
the device, and observe them during operation.
This symbol warns of hot surfaces the contact with which may cause injury.
This symbol warns of hand injury that may occur when reaching into the device in operation.
The symbol with the arrow indicates special advice and notes.
3. Intended Use
The 3D printer produces 3D-objects from suitable printing files. For this, suitable raw material (filament) is melted in the print head
and attached in the required position for the object.
This product is only approved for connection to 100-240 V/50/60 Hz alternating current and only for use in the private area.
It is intended for indoor operation only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be avoided under
This product is only approved for connection to 100-240 V/50/60 Hz alternating current and only for use in the private area.
It is intended for indoor operation only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be avoided under
all circumstances.
Any use other than that described above will damage this product and involves the risk of short circuit, fire, electric shock, etc.
This product complies with the statutory national and European requirements. All company names and product names are trade-
Any use other than that described above will damage this product and involves the risk of short circuit, fire, electric shock, etc.
This product complies with the statutory national and European requirements. All company names and product names are trade-
marks of their respective owners. All rights reserved.
ATTENTION Mains voltage - the connection, installation and wiring of the electrical components must only be perfor-
med by an electrician who is familiar with the applicable safety provisions. Before commissioning, inspection accor-
ding to the applicable safety provisions must be performed by an electrician.
med by an electrician who is familiar with the applicable safety provisions. Before commissioning, inspection accor-
ding to the applicable safety provisions must be performed by an electrician.
Observe all safety and assembly notes in these operating instructions!
. Safety Information
The guarantee/warranty will expire if damage is incurred resulting from non-compliance with these operating instruc-
tions. We do not assume liability for any consequential damage.
tions. We do not assume liability for any consequential damage.
Nor do we assume any liability for damage to property or personal injury caused by improper use or failure to observe
the safety information. In such cases the warranty/guarantee is voided.
the safety information. In such cases the warranty/guarantee is voided.
Dear Customer: The following safety information is intended not only for the protection of the device but also for the
protection of your health. Please read through the following attentively:
• For safety reasons, any unauthorized conversions and/or modifications to the product deviating from these operating
• For safety reasons, any unauthorized conversions and/or modifications to the product deviating from these operating
instructions are not permitted. Components may be damaged and thus impair the function or safety of the device.
• When setting up the 3D printer, observe that the mains switch at the rear of the device must be easy to reach so that
the device can be switched off quickly and easily in case of malfunction.