Renkforce 3D printer RF1000 Single extruder (value.974113) RF1000 Data Sheet

 If the motors are moved manually, the display may light up. This is not a malfunction. A voltage induced by the movement

causes the display to light up.

Connection of the earthing plate

Place the heating plate onto the spacer bolts of the undertable

and connect the two plug connectors from line 12 and 20.

Basic setting limit switch Z-direction

Loosen the actuation screw in the Y-plate for the limit switch in

the Z-direction and turn it all the way into the hexagon bolt.

Carefully turn the toothed belt of the bottom plate until there is

a gap of 0.5 mm (+/-0.2 mm) set between the heating plate and

extruder. 0.5 mm correspond roughly to the thickness of 5 lay-

ers of printer paper (80 g/m²).
Caution: No force must be applied to the heating plates, since
the  ceramics  material  would  break  otherwise  (loss  of  war-
ranty/guarantee).

Set the adjustment screw so that the limit switch of the Z-di-

rection is tripped in this position (a slight click is audible).

Move the extruder and Y-plate manually and ensure that the

extruder cannot touch the heating plate anywhere in the work-

ing area and that the same distance is complied with every-

where.

If  this  is  not  the  case,  the  undertable  plate  must  be  aligned

carefully.  However,  the  heating  plate  must  be  taken  off  first

(danger of breaking!).

After  this  setting,  counter  the  setting  screw  with  the  nut

again.