Renkforce 3D printer RF1000 Single extruder (value.974113) RF1000 Data Sheet
Product codes
RF1000
73
d) Manual Operation via the Software
Click the tab “Manual Control” on the main screen of the software.
Before trying out manual printer control, the settings for the limit switches for the Z and Y axes must have been per-
formed (see pages 31 and 5). In the finished device, this has already been performed at production but should be
inspected again for reasons of safety.
formed (see pages 31 and 5). In the finished device, this has already been performed at production but should be
inspected again for reasons of safety.
If this is not observed, there may be damage to the 3D printer (loss of warranty/guarantee).
(1) Printer moves into the home position
(2) X-axis moves into the home position
(3) Y-axis moves into the home position
(4) Z-axis moves into the home position
(5) The arrow icons can be used to operate the corresponding axes manually. Depending on where the arrow is clicked,
(2) X-axis moves into the home position
(3) Y-axis moves into the home position
(4) Z-axis moves into the home position
(5) The arrow icons can be used to operate the corresponding axes manually. Depending on where the arrow is clicked,
differently long routes are run. The route length is displayed when the mouse pointer is moved across the corresponding
button of the arrow.
(6) Switch off motors to move them manually.
(7) Printer moves into the parking position.
(8) Switching the extruder heating on/off, e.g. to heat the extruder before filament change. Below this, the temperature and
(7) Printer moves into the parking position.
(8) Switching the extruder heating on/off, e.g. to heat the extruder before filament change. Below this, the temperature and
filament infeed can be operated.
(9) Switching the heating bed on/off. Below this, the temperature can be set.