Renkforce 3D printer RF1000 Single extruder (value.974113) RF1000 Data Sheet
Product codes
RF1000
1
b) Wiring of the Components
Extruder
Drag chain 15 links open on the inside
Lines 14, 15 and 19
Push the lines into the drag chain so that the end link points to
the line ends without label with the nipples.
Latch the drag chain at the extruder carriage and pull the lines
from the drag chain until they can be plugged into the connec-
tions of the extruder carriage cleanly placed.
Connect the lines to the respective matching plugs.
Caution: the line with the blue/red wires is connected to the
fan. This is the only line that can be swapped due to its plug.
Caution: the line with the blue/red wires is connected to the
fan. This is the only line that can be swapped due to its plug.