Renkforce 3D printer RF1000 Single extruder (value.974113) RF1000 Data Sheet
Product codes
RF1000
9
c) Installation of the PCBs
The components on the PCBs can be damaged by electrostatic discharge. Therefore, touch, e.g. an earthed radiator
before taking any PCBs into your hand.
before taking any PCBs into your hand.
Installation of the display and keyboard PCB
1x keyboard PCB
1x display PCB
4x spacer roller 8 mm for keyboard PCB
4x spacer roller 9 mm for display PCB
8x cylinder head screw M2x16
8x nut M2
1x flat band line with twisted plugs
Connect the flat band line to the keyboard PCB. Observe cor-
rect position of the latching tabs at the plugs.
Install the keyboard PCB as shown with the spacer rollers 8
mm. The spacer rollers may be fastened at the PCB with a drop
of hot glue for easier assembly first.
Apply all screws in the area of the nuts with threadlocker var-
nish.
The plug connector with the flat band line must point to the top
of the device.
Align the PCB so that the keys are not caught in the housing
cut-outs.
Remove the protective foil from the display.
Install the display PCB with the spacer rollers 9 mm as shown.
Apply all screws in the area of the nuts with threadlocker var-
nish.
The small additional PCB with the plug connector point to the
top of the device.
Align the PCB so that the display is at a right angle to the hous-
ing cut-out.