Renkforce 3D printer RF1000 Single extruder (value.974113) RF1000 Data Sheet
Product codes
RF1000
58
b) Insertion of the Filament
Pull the filament hose end from the infeed basic part.
Push the filament roller onto the filament holder and guide the
filament through the filament hose until it escapes on the other
side.
The filament roller must move freely.
Cut into the filament end at a 45°-angle. Insert the filament
through the bore and past the feed motor into the extruder to
the stop.
Push the filament hose end into the infeed basic part.
Tighten all spring screws so that the filament is cleanly guided
but also is not deformed badly by the filament feed.
It must be possible for the feed motor to turn without slippage
or catching when pulling or pushing at the filament.
The filament must be guided in a straight line from the top be-
tween the feed motor and the ball bearing into the bore at the
extruder. It must not catch at the bore edge of the extruder.