TP-LINK 24-Port 10/100Mbps + 4-Port Gigabit L2 Managed Switch TL-SL3428 Data Sheet

 

 

Figure 7-4 STP Config 

The following entries are displayed on this screen: 



Select Enable/Disable STP function globally on the switch. 

 

Select the desired STP version on the switch. 


 STP: Spanning Tree Protocol. 



  RSTP: Rapid Spanning Tree Protocol. 



  MSTP: Multiple Spanning Tree Protocol. 

 



Enter a value from 0 to 61440 to specify the priority of the switch 
for comparison in the CIST. CIST priority is an important criterion 
on determining the root bridge. In the same condition, the switch 
with the highest priority will be chosen as the root bridge. The 
lower value has the higher priority. The default value is 32768 and 
should be exact divisor of 4096. 

Enter a value from 1 to 10 in seconds to specify the interval to 
send BPDU packets. It is used to test the links. 2*(Hello Time + 1) 
≤ Max Age. The default value is 2 seconds.   

Enter a value from 6 to 40 in seconds to specify the maximum 
time the switch can wait without receiving a BPDU before 
attempting to reconfigure. The default value is 20 seconds. 

Enter a value from 4 to 30 in seconds to specify the time for the 
port to transit its state after the network topology is changed. 
2*(Forward Delay-1) ≥ Max Age. The default value is 15 seconds.

Enter a value from 1 to 20 to set the maximum number of BPDU 
packets transmitted per Hello Time interval. The default value is 
5pps. 

77