TP-LINK 16-Port Gigabit Web Smart Switch with 2 Combo SFP Slots TL-SG2216WEB Data Sheet
Product codes
TL-SG2216WEB
no storm-control unicast
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
gigabitEthernet)
Example
Enable the unicast control function for port 5:
TL-SG2452(config)# interface gigabitEthernet 1/0/5
TL-SG2452(config-if)# storm-control unicast
storm-control rate
This command is supported only on TL-SG2452.
Description
The
storm-control rate command is used to configure storm control rate. To
disable the storm control function, please use
no storm-control rate command.
Storm Control function allows the switch to filter broadcast, multicast and UL
frame in the network. If the transmission rate of the three kind packets exceeds
the set bandwidth, the packets will be automatically discarded to avoid network
broadcast storm.
frame in the network. If the transmission rate of the three kind packets exceeds
the set bandwidth, the packets will be automatically discarded to avoid network
broadcast storm.
Syntax
storm-control rate rate
no storm-control rate
no storm-control rate
Parameter
rate —— The maximum ingress rate of the storm control packets. The packet
traffic exceeding the bandwidth will be discarded. The value of it can be 128k |
256k| 512k|1m | 2m | 4m | 5m | 10m | 20m | 40m | 50m in bps.
traffic exceeding the bandwidth will be discarded. The value of it can be 128k |
256k| 512k|1m | 2m | 4m | 5m | 10m | 20m | 40m | 50m in bps.
Command Mode
Interface gigabitEthernet / Interface range gigabitEthernet
Example
Specify the storm control rate as 2Mbps for port5:
TL-SG2452(config)# interface gigabitEthernet 1/0/5
TL-SG2452(Config-if)# storm-control rate 2m
96