Datalogic PowerScan PD9500 PD9530-HPK1 Data Sheet
Product codes
PD9530-HPK1
HLD-P080
Desk/Wall Holder
Mounting Instructions
The HLD-P080 is a plastic holder for the PowerScan™ 8000 and
PowerScan™ 9000 families of barcode readers, designed to be
mounted on a wall or fixed to a desk.
PowerScan™ 9000 families of barcode readers, designed to be
mounted on a wall or fixed to a desk.
Installation
The mounting kit supplied with the holder contains the following
components:
components:
•
1 HLD-P080
•
1 spacer
•
2 self-tapping screws
•
2 threaded dowels
•
2 adhesive strips
When used with PowerScan™ 8000 readers without display, the
spacer must be installed to the holder as shown in Figure 1.
spacer must be installed to the holder as shown in Figure 1.
Figure 1
.
Desktop Use
To fix the HLD-P080 to a desktop, use the double-sided adhesive
strips following the steps below:
strips following the steps below:
1.
Carefully clean the surfaces of the desk and of the bottom of
the HLD-P080 with alcohol to remove any impurities that
could reduce the adhesion.
the HLD-P080 with alcohol to remove any impurities that
could reduce the adhesion.
2.
Remove the protective plastic from one side of the adhesive
strips and stick them on the HLD-P080 bottom as shown in
Figure 2.
strips and stick them on the HLD-P080 bottom as shown in
Figure 2.
Figure 2
3.
Remove the plastic from the other side of the strips and affix
the HLD-P080 to the desk.
the HLD-P080 to the desk.
Wall-Mount Use
Wall mounting is accomplished using the two threaded dowels and
the self-tapping screws, which will be inserted into the two holder
mounting holes.
the self-tapping screws, which will be inserted into the two holder
mounting holes.
Figure 3
1.
Using the holder mounting holes as a pattern, mark the wall
where you desire to mount the HLD-P080.
where you desire to mount the HLD-P080.
2.
Drill two appropriate-size holes.
3.
Insert the threaded dowels into the holes.
4.
Position the holder on the wall with the opening inclined
upwards and affix it by means of the two screws.
upwards and affix it by means of the two screws.
Figure 4
Mounting
holes
holes
820057014 (Rev. C) February 2014
©2007-2014 Datalogic, Inc. • All rights reserved. Datalogic and the Datalogic logo are regis-
tered trademarks of Datalogic S.p.A.in many countries, including the U.S.A. and the E.U.
tered trademarks of Datalogic S.p.A.in many countries, including the U.S.A. and the E.U.