Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Data Sheet

The various functions used in the T14SG can 

be activated by a switch. For the purposes of this 

manual, a stick position, VR position, etc. shall be 

commonly referred to as a switch in all cases.  That 

(Switch selection screen example)

When switch was selected, ON/OFF position 

setting is also performed.

*The ON/OFF setting state of each position is displayed.

1. When you want to change the ON/OFF

setting, use the touch sensor to move the

cursor and touch the RTN button to switch

to the data input mode. Switch the ON/

Off display by scrolling the touch sensor.

*ON/OFF display blinks.

3.  When  the  RTN  button  is  touched,  the

ON/OFF setting is changed. (Touch the S1

button to stop the change.)

4. To return to the preceeding screen, move

the cursor to the [ON/OFF] at the top of

the screen and touch the RTN button.

When a stick, trim lever, or knob is used as a 

switch, two operation modes can be selected:

1. When you want to change the mode,

move  the  cursor  to  [MODE]  item  and

touch  the  RTN  button  to  switch  to  the

data  input  mode.  Switch  the  display

to  the  mode  you  want  to  change  by

scrolling the touch sensor and then make

the change by touching the RTN button.

 ●Mode: [LIN]/[SYM]

*Set the ON/Off point by the method described on the next page.

1. Use the touch sensor to move the cursor

(highlights)  to  the  switch  you  want  to

select and touch the RTN button.

*The switch blinks.

2. To return to the preceeding screen, move

the cursor to the [H/W SELECT] at the top

of the screen and touch the RTN button.

 Or, move the cursor to the [ON/OFF] and

call the ON/OFF position setting screen by

touching the RTN button.

 ●ALTERNATE mode: [OFF]/[ON]
1. Move the cursor to the [ALTERNATE] item

and touch the RTN button to switch to the

data input mode.

2. Change to the mode you want to set by

scrolling the touch sensor.

*The mode display blinks.

3. Touch the RTN button. (Touch the S1 button

to stop the change.)

4. To return to the preceeding screen, move

the cursor to the [ON/OFF] at the top of the

screen and touch the RTN button.

When a switch is selected at a mixing function, etc., the selection screen shown below is called.

is, whenever the manual indicates that something is 

operated via a switch, it is possible for the user to 

activate this setting via a stick, stick position, etc.