Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Data Sheet
Product codes
1-F8075
32
<Before Use>
Telemetry System
The R7008SB receiver features bi-directional communication with a FASSTest Futaba transmitter using the
S.BUS2 port. Using the S.BUS2 port an impressive array of telemetry sensors may be utilized. It also includes
both standard PWM output ports and S.BUS output ports.
* Telemetry is available only in the FASSTest 14CH mode. (12CH mode displays only Receiver battery voltage
* Telemetry is available only in the FASSTest 14CH mode. (12CH mode displays only Receiver battery voltage
and Extra battery voltage.)
* The telemetry function requires the corresponding receiver (R7008SB).
* The T14SG will enter and keep the ID number of the R7008SB that it is linked to.
* The T14SG will enter and keep the ID number of the R7008SB that it is linked to.
S.BUS2
Connector
Temperature
Sensor
Slot 1
Slot 2
Slot 3 ∼ 5
Slot 6
Slot 7
Slot 8 ∼ 15
Slot 16
Receiver
Battery voltage is
displayed at the transmitter.
Drive battery voltage is
displayed at the transmitter.
Switch
T14SG
Terminal box
HUB
HUB
HUB
Info
Info
Info
Info
Info
voltage
Signal
RPM
Sensor
Altitude
Sensor
Voltage
Sensor
GPS
Sensor
Slot 17
***Sensor
***Sensor
***Sensor
●Telemetry sensor (sold separately)
Your aircrafts data can be checked in the
Your aircrafts data can be checked in the
transmitter by connecting various telemetry
sensors to the S.BUS2 connector of the
receiver.
●Slot No.
Servos are classified by channel, but sensors
are classified by “slot” . Since the initial slot
No. of the T14SG is preset at each sensor,
the sensors can be used as is by connecting
them. There are 1 31 slots.
Info