Reely Hendheld RC 2.4 GHz No. of channels: 6 1310037 User Manual

Even though the remote control system was built to the state of the art, there can still be interference or faults. For this 

reason, we would like to give you some information on how to deal with possible problems.

Transmitter doesn’t respond

•  Check the batteries in the transmitter.
•  Check the polarity of the batteries.
•  Check the battery contacts of the remote control.
•  Check the on/off switch.

The servos do not respond

•  Check the batteries in the receiver.
•  Test the switch cable.
•  Test the BEC function of the controller.
•  Check the polarity of the servo connector.
•  Check digital code.
•  Perform binding again.
•  For test purposes, change the receiver and bind again.

The servos vibrate

•  Check batteries in the remote control and the receiver.
•  Check connectors on the receiver.
•  Dry the receiver with a hair dryer in case it has gotten wet.
•  Check the receiver aerials for damage.
•  Reorient the receiver aerials in the model for test purposes.

One servo is humming

•  Check the batteries in the receiver.
•  Make sure the linkage rods run smoothly.
•  Operate the servo without the servo arm for test purposes.

The  range  of  the  system  is  very 

short

•  Check the batteries in the transmitter and receiver.
•  Check the receiver aerials for damage.
•  Reorient the receiver aerials in the model for test purposes.

Transmitter switches off on its own 

at once of after a short period

•  Check or replace the batteries in the transmitter.