Conrad DP-M13 Digital Microscope Magnification, 2.0 Megapixel DP-M13 Data Sheet

Double-click on the picture to enter into measurement interface. Under the ‘Measurement’ icon 

, you 

can choose any desired options to measure. 

1. Any Angle Line Measurement 

Simply click from one point and drag to the next point, and then click again to lock-in. 

2. Straight Angle Line Measurement 

The Line measurement allows you to measure from one point to the next. Simply click and drag to the 

desired length, and then click again to lock-in. 

3. 45 Degrees’ Angle Line measurement 

This function is for any 45 Degrees’ Angle Line angle measurement. Simply click and drag to extend out 

to the desired angle. 

4. Continuous Line Measurement       

The Continuous Line measurement allows you to measure any continuous desired length. 

Simply click and drag from one point to other desired points, click again to lock-in. 

5. Polygon Measurement 

    The Polygon Measurement allows you to measure the side-length, interior angle degree, circumference 

and area of the polygon. 

6. Radius Circle Measurement 

    Simply click and extend out to the desired radius, the radius, circumference and area of the circle will 

show up accordingly. 

7. Diameter Circle Measurement 

    Simply click and extend out to the desired diameter, the radius, circumference and area of the circle will 

show up accordingly. 

8. Three Points Circle Measurement     

    Simply define any three points and click, the radius, circumference and area of a circle will show up 

accordingly. 

9. Three Points Arc Measurement   

    Simply define any three points and click, the circumference of the arc as well as the radius and area of the 

sector will show up accordingly. 

10. Three Points Angle Measurement 

      This function allows measurement of an angle. Simply click and drag to extend out to the desired angle. 

11. Four Points Angle Measurement 

      Simply define any two points and click for the first line, and repeat the action to create the second line, 

the angle degree between two lines show up accordingly. 

If change the magnification rate and adjust focus to capture picture, please calibrate the magnification rate 

again.

 

1. Double click to open the picture, Click ‘

  > Reset magnification > Reset picture magnification’ as 

below. And then start calibration again (Calibration details please refer to page5, 6). 

                                                                                                                                                                      7