Intel E3815 FH8065301567411 Data Sheet
Product codes
FH8065301567411
Intel
®
Atom™ Processor E3800 Product Family
Datasheet
663
14.11.23 CRTIO_DFX—Offset 61104h
CRT port control (dprrega.v crt_dfx)
Access Method
17
0b
RW
CRT_Hot_Plug_Reference_Voltage:
Project: All
Default Value: 0b
Value Name Description Project
0b 325mv 325mv All
1b 475mv 475mv (bits 19:18 must be = 11) All
16
0b
RW
Force_CRT_Hot_Plug_Detect_Trigger:
Project: All
Default Value: 0b
Triggers a CRT hotplug/unplug detection cycle independent of the hot plug detection
enable bit. This bit is automatically cleared after the detection is completed. The result
of this trigger is reflected in the CRT Hot Plug Detection Status. Software must reset
status after a force CRT detect trigger.
Value Name Description Project
0b No Trigger No Trigger All
1b Force Trigger Force Trigger All
15:10
0b
RW
Reserved_1:
Project: All Format:
9:5
0b
RW
CRTFullScaleOutputVoltageTrimmingControl:
Project: All
Default Value: 0b
This controls CRT output voltage trimming to ensure the output voltage is withing VESA
spec.
4
0b
RW
VSYNC_Polarity_Control:
Project: All
Default Value: 0b
The output VSYNC polarity is controlled by this bit. This is used to implement display
modes that require inverted polarity syncs and to set the disabled state of the VSYNC
signal.
Value Name Description Project
0b Low Active Low All
1b High Active High All
3
0b
RW
HSYNC_Polarity_Control:
Project: All
Default Value: 0b
The output HSYNC polarity is controlled by this bit. This is used to implement display
modes that require inverted polarity syncs and to set the disabled state of the HSYNC
signal.
Value Name Description Project
0b Low Active Low All
1b High Active High All
2
0b
RW
Reserved_2:
Project: All Forma
1
0b
RW
Reserved_3:
Project: All Forma
Monochrome Enable: [DevVLVP] If the CRT display is a monochrom type, SW driver
shall set this bit to enable the CRT circuit to drive only the green channel to CRT and
gate off the red and blue channels. 0 = Monochrome disabled (default) 1 = Monochrome
enabled
0
0b
RW
Reserved_4:
Project: All Forma
Monochrome Enable: [DevVLVP] If the CRT display is a monochrom type, SW driver
shall set this bit to enable the CRT circuit to drive only the green channel to CRT and
gate off the red and blue channels. 0 = Monochrome disabled (default) 1 = Monochrome
enabled
0 = 1.35V is used for analog supply voltage (default) 1 = 1.25V is used for analog
supply voltage
Bit
Range
Default &
Access
Field Name (ID): Description