Bunn Ice Tea Maker AFPO-3 User Manual

11

Location:

 

The fuse holder is located on the lower right front 

of the autofill box just to the left of the power cord.

Test Procedure:

1.  Disconnect the dispenser from the power source.

2.  Remove cap and fuse from fuse holder.

3.  Remove fuse from the cap.

4.  Check for continuity through the fuse.

If continuity is present, reinstall the fuse, the fuse is 

operating properly.

If continuity is not present, replace the fuse.

 

FIG. 4 FUSE HOLDER

P1516

Removal  and Replacement:

Fuse:

1.  Remove the cap from the fuse holder.

2.  Remove fuse from the fuse holder and inspect. If 

blown, discard.

3.  Install new 10 amp fuse in the fuse holder.

4.  Reinstall fuse holder cap.

Fuse Holder:

1.   Disconnect the dispenser from the power source.

2.  Disconnect the wires from the rear of the fuse 

holder.

3.  Remove the nut securing the fuse holder to the 

front of the main mounting panel.

4.  Push the fuse holder through the hole in the 

panel.

5.  Install new fuse holder and fuse through the hole 

in the panel.

6.  Secure the fuse holder to the panel. 

7.  Refer to Fig. 5 and reconnect the wires. 

BLK from Main

Wiring Harness

BLK to Main

ON/OFF Switch

FIG. 5 FUSE HOLDER TERMINALS

P1331

41093 040408