Hotbrick Dual WAN Firewall VPN 1400/2 User Manual
HotBrick, Tel: 305-398-0888, Fax: 305-398-5966
settings to correct the problem.
Enable - If enabled, the WAN port you specify will be used for all outgoing SMTP
traffic. If disabled, either WAN port will be used.
WAN – Select the desired WAN port to be bound.
Protocol and Port Bindings - Use these settings if you wish to ensure that particular traffic
is sent by a particular WAN port, and thereby a particular ISP account.
is sent by a particular WAN port, and thereby a particular ISP account.
Enable - Enable or disable each item as required.
Source IP - IP address of the source sending the packets.
Destination IP – IP address of the destination receiving the packets.
Subnet Mask – With a subnet mask other than 255.255.255.255, you can make an IP subnetwork
Source IP - IP address of the source sending the packets.
Destination IP – IP address of the destination receiving the packets.
Subnet Mask – With a subnet mask other than 255.255.255.255, you can make an IP subnetwork
your destination.
Protocol – Select protocol type used by the traffic you wish to configure.
Port Range - Enter the beginning and end of the port range used by the traffic you wish to
configure. If only a single port is used, enter the port number in both fields.
WAN - Select the WAN port you wish this traffic to use.
Protocol and Port Binding List - This list shows the details of all protocol and port configuration data
that are currently defined. You can modify them by mouse clicking the correct row.
that are currently defined. You can modify them by mouse clicking the correct row.
39