Behringer Europower PMP960M Brochure

Page 3 of 7

Internal switch-mode power supply, 
noise-free audio, superior 
transient response and very low 
power consumption

Rack mount brackets included

High-quality components and 
exceptionally rugged construction 
ensure long life

Conceived and designed by 
BEHRINGER Germany

This is where the FBQ feature comes 

in particularly handy. Press the FBQ IN 
switch to activate the Feedback Detection 
System. Trouble frequencies are indicated 
by brightly lit fader LEDs. Just lower 
the level of the respective frequency 
range until feedback disappears and the 
LED goes out.

The FX RET controls add the 

selected effect signal to the main 
or monitor mix. When both are 
completely counterclockwise, no effect 
is applied. The 2TR IN control adjusts 
the volume of the 2 Track signal, if you 
have connected one.

Use the MAIN MASTER/MONITOR 

MASTER controls to adjust the main and 
monitor output signals, respectively. 
The 5-digit LED meters give you a 
visual representation of these volumes. 
The upper LIM LED illuminates when 
output levels are too high, activating the 
internal amp protection circuit.

PMP980S’ POWER AMP switch 

toggles between three operating modes: 
STEREO (main left and right outputs), 
MON/MONO (Output A can be used to 
power Monitors and Output B to power 
Mains in mono) and BRIDGE (the power 
outputs of A and B on the back panel 
are added and provided at OUTPUT B). 
The PMP960M provides similar options: 
MAIN/MAIN Bridge (outputs of A and 

B are added and provided at OUTPUT 
B), MAIN/MAIN non-Bridge (dual mono 
amps), and MAIN/MON mono (Output A 
can be used to power Mains and Output 
B to power Monitors). This clever 
functionality enables you to power both 
your mains and monitors withoutthe 
need for an additional power amp just for 
your monitors.

Directly below, you’ll find the SPEAKER 

PROCESSING switch that activates a filter 
in both models, adapting the mixer to the 
frequency response of your loudspeakers.

Finally, the STANDBY switch lets you 

mute all input channels during breaks, 
preventing the microphones from picking 
up noise or interference. You can leave all 
faders untouched while you play a CD via 
the CD/TAPE inputs.

At just 20.75 lbs / 9.4 kg and 

18.75 lbs / 8.5 kg respectively, the 
PMP980S and PMP960M were designed 
specifically for gigs that don’t call for a 
massive PA system. Small, simple events 
call for a lightweight, simple powered 
mixer, and these are the most efficient, 
affordable mixers for the job. They are 
easy to learn, easy to operate, and with 
so many incredible built-in features, 
they make it easy to put on a show 
in an instant.

Dual Footswitch

PMP980S Front Panel

(Excerpt)

2 x BEHRINGER

B312A (Active)