Westinghouse WP2700 Owner's Manual

 

39

  1 -  Pump/Engine
 Mounting 

Bolts

  2 -  Engine
 Crankshaft

4.  Apply a thin layer of grease to the crankshaft before 

installing the pump.

5.  Inspect the key and keyway on crankshaft (see 

Figure 55).

6.  Slide the pump onto the crankshaft making sure the 

key lines up with the keyway in the pump.

7.  Install the pump/engine mounting bolts and tighten 

to 25 ft-lb (34 N·m).

1.  Disconnect high-pressure hose and soap siphon 

hose from pump.

2.  Remove the 4 mounting bolts and washers holding 

the pump to the engine (see Figure 56).

3.  Slide the pump out off of the crankshaft (see Figure 

56).

4.  Inspect the key and keyway on crankshaft (see 

Figure 57). 

5.  Apply a thin layer of grease to the crankshaft before 

installing the pump.

6.  Slide the pump onto the crankshaft making sure the 

key lines up with the keyway in the pump.

7.  Install the pump/engine mounting bolts and tighten 

to 30 ft-lb (41 N·m).