Bunn LCR-3 User Manual

7

  

(Refer to the Tubing Installation Instructions in side the cabinet door for details.)

1.  Loosen the thumbscrew securing the tubing retainer plate to the pump housing. Set the retainer plate aside.

2.  Depress the tension screw and remove it from the notch in the pump body, releasing the pump compression band.

3.  Apply lubricant (BUNN-O-MATIC part number M2531.0001) to the new pump tubing.

4.  Insert the tubing onto the mix chamber port and wrap the tubing around the pump rotor, making sure that the elbow and clamps 

end up on the bottom side of the pump body.

5.  Close the compression band reinsert the tension screw into the notch in the pump housing.

6.  Replace the tubing retainer plate and tighten the thumbscrew.

7.  Reconnect bag connector to the product box.

8.  Repeat steps 1 through 7 for the other two pumps.

9.  Prime the pumps.  Refer to Priming the Concentrate Lines section.

Remove Retaining Plate Release Spring Tension

Remove Tubing

Lubricate New Tube

Install New Tubing

Completed Installation

41129 110608

1.  Unscrew the middle and right front legs (Fig. 1) - just enough to allow the mounting bracket to slide under the legs, (~1/8”).  

2.  Insert the bracket between the legs and the base of the machine and retighten the legs, (Fig. 2).

        

Fig. 1   

 

 

 

 

 

Fig. 2

3.  Insert the Drip Tray onto the mounting bracket, (Fig. 3). Make sure the drain fitting is still protruding through the hole.

Fig. 3

A separate drain tube (not supplied) may be attached to fitting in the bottom of the tray, if desired. Note: Drill a ¼” hole in the center 

of the fitting, before attaching the drain hose. Direct the other end of this hose into a permanent drain. 

For locations where the Drip Tray is not desired, connect a separate drain hose (not supplied) to the Evaporator Drain Fitting and direct 

the other end of this hose into a permanent drain.