Bunn Single SH DBC* (with Smart Funnel) Owner's Manual

Page 13

MUST GRIND INTO 

FUNNEL FIRST 

(COFFEE NAME) 

SETUP COMPLETE 

BEGIN SETUP OF 

(COFFEE NAME) 

QUIT SETUP? 

YES 

INSERT FUNNEL 

WITH NEW NAME 

REVIEW RECIPES? 

NO                       YES 

(COFFEE NAME) 

NO                       YES 

3 BATCHES DONE? 

NO                       YES 

SET NEW RECIPE? 

NO                       YES 

2 SEC. 

CYCLES THROUGH 

TWO SCREENS 

FUNNEL 

CONTAINS NAME 

FUNNEL CONTAINS 

NO NAME 

SETUP BREW VOLUMES, BYPASS, PULSE BREW, 

PREINFUSION, DRIPOUT TIME 

SEE SEPARATE DIAGRAMS 

FOR SETUP INSTRUCTIONS 

FUNNEL DETECTED 

P2439

NOTE: Before beginning setup, place a server beneath 

the sprayhead.

1.  Insert the funnel into the grinder and select a batch 

size to grind. It is not necessary to have coffee beans 

in the hopper(s) in order to program the brewer. 

The coffee name is pre-selected and stored in the 

grinder's memory for the side being ground.

2.  Press the 

 pad. When the grinder stops grind-

ing, remove the funnel.

3.  On the brewer, press and hold the ® pad until the 

display reads SET NEW RECIPE. Release the ® 

pad.

4.  Press and release YES. The display should read 

INSERT FUNNEL WITH NEW NAME, then QUIT 

SETUP? These two displays will repeatedly 

cycle.

5.  Insert  the funnel into the rails of the brewer. The 

display should read the NAME of the coffee that 

was ground into the funnel, along with a NO and 

YES. If the NAME on the display is correct, press 

YES. 

6.  If, for some reason, the name of the coffee from 

the grinder did not load properly into the funnel, 

or if a grind has not yet been done, the display will 

read MUST GRIND INTO FUNNEL FIRST. It will be 

necessary to grind another batch following steps 

1 and 2.

7.  If the grind is acknowledged by the brewer, the 

display will read BEGIN SETUP OF (COFFEE 

NAME). Then the screen will display BREW OZ. 

and a batch light will be blinking. (Refer to page 

19 for description of BREW OZ. function).

 

This function allows the operator to set BREW VOL-

PREINFUSION TIMES and DRIP-OUT TIMES for each 

coffee name preset in the grinder's memory.

  Certain coffee NAMES are stored in the G92T 

DBC's memory. When a particular name of coffee is 

ground into the Smart Funnel, that name and the batch 

size selected are transferred from the grinder to the 

programming chip located in the funnel handle. The 

funnel is then inserted into the brewer's left side funnel 

rails. The sensor coil on the brewer reads the informa-

tion contained in the handle. The name of the coffee 

flavor will then appear on the display. This then allows 

the operator to set the BREW VOLUMES, BYPASS 

TIMES and DRIP-OUT TIMES  for that particular coffee 

NAME. It also allows the operator to set other brewing 

parameters, such as BREW TEMPERATURE, READY 

TEMPERATURE, BREW LOCKOUTS, etc. Each coffee 

NAME can be set individually to provide optimum 

brewing quality.

BREW OZ.  XX.X 

(-)        DONE        (+) 

% BYPASS  XX.X 

(-)        DONE        (+) 

3 BATCHES DONE? 

NO                     YES 

P2415

34025  022509