Bunn ICB, Twin, Tall, Twin Tall Owner's Manual

Page 5

41581 120312

1.  An electrician must provide electrical service.

2.  Determine the available on-site electrical service.

3.  (DV models only) Select the desired unit voltage based on the available on-site electrical service.

4.  Using a voltmeter, check the voltage and color coding of each conductor at the electrical source.

5.  Remove the front access panel to gain access to the terminal block.

6.  Feed the power cord through the strain relief and connect it to the terminal block(s).

7.  Connect the power cord to the terminal block as shown.

8.  Before proceeding, verify the voltage at the field wiring terminal block.

9.  (DV models only) Set voltage switch to the appropriate position and replace the access panel.

10.  If plumbing is to be hooked up later be sure the brewer is disconnected from the power source.  If 

plumbing has been hooked up, the brewer is ready for Initial Set-Up.

WARNING - The brewer must be disconnected from the power source until specified.

WARNING - The power cord must be UL Listed, Flexible Cord Type SO, SJO, SJTO, HSJO or SJOW, Rated 90° 

C, and the attachment plug cap must be UL Listed, in order to avoid a hazard. The Power Supply Cord must 

be at least 3 feet long and maximum 6 feet long (measured from Strain Relief to end of the Attachment 

Plug Cap).

N

L1

G

L2 RED

L2 RED

POWER CORD

WHITE

GREEN

NEUTRAL

L1 BLACK

WHITE

NEUTRAL

L2

L1 BLACK

WHITE

NEUTRAL

L1 BLACK

N

L1

G

POWER CORD

GREEN

WHITE

NEUTRAL

L1 BLACK

L2 RED

L2 RED

L2

L1 BLACK

L1

G

POWER CORD

GREEN

L1 BLACK

L2 RED

NEUTRAL BLUE

N

L1 BLACK

L1

G

POWER CORD

GREEN/YELLOW

L1 BROWN